SH7206 Datasheet, PDF (784/1188 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series

Section 15 Serial Communication Interface with FIFO (SCIF)
15.3.11 Serial Port Register (SCSPTR)
SCSPTR controls input/output and data of pins multiplexed to SCIF function. Bits 7 and 6 can
control input/output data of RTS pin. Bits 5 and 4 can control input/output data of CTS pin. Bits 3
and 2 can control input/output data of SCK pin. Bits 1 and 0 can input data from RxD pin and
output data to TxD pin, so they control break of serial transmitting/receiving.
The CPU can always read and write to SCSPTR. SCSPTR is initialized to H'0050 by a power-on
reset.
Bit: 15 14 13 12 11 10 9
-
-
-
-
-
-
-
Initial value: 0
0
0
0
0
0
0
R/W: R
R
R
R
R
R
R
8
7
6
5
4
3
2
1
0
- RTSIO RTSDT CTSIO CTSDT SCKIO SCKDT SPB2IOSPB2DT
0
0
1
0
1
0
0
0
0
R R/W R/W R/W R/W R/W R/W R/W R/W
Bit
15 to 8
Bit Name
—
7
RTSIO
6
RTSDT
Initial
Value
All 0
0
1
R/W Description
R Reserved
These bits are always read as 0. The write value should
always be 0.
R/W RTS Port Input/Output
Indicates input or output of the serial port RTS pin.
When the RTS pin is actually used as a port outputting
the RTSDT bit value, the MCE bit in SCFCR should be
cleared to 0.
0: RTSDT bit value not output to RTS pin
1: RTSDT bit value output to RTS pin
R/W RTS Port Data
Indicates the input/output data of the serial port RTS
pin. Input/output is specified by the RTSIO bit. For
output, the RTSDT bit value is output to the RTS pin.
The RTS pin status is read from the RTSDT bit
regardless of the RTSIO bit setting. However, RTS
input/output must be set in the PFC.
0: Input/output data is low level
1: Input/output data is high level
Rev. 3.00 Jun. 18, 2008 Page 760 of 1160
REJ09B0191-0300