SH7206 Datasheet, PDF (494/1188 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series

Section 10 Multi-Function Timer Pulse Unit 2 (MTU2)
Initial
Bit
Bit Name Value R/W Description
0
ITB4VE
0*
R/W TCIV_4 Interrupt Skipping Link Enable
Select whether to link A/D converter start requests
(TRG4BN) with TCIV_4 interrupt skipping operation.
0: Does not link with TCIV_4 interrupt skipping
1: Links with TCIV_4 interrupt skipping
Notes: 1. TADCR must not be accessed in eight bits; it should always be accessed in 16 bits.
2. When interrupt skipping is disabled (the T3AEN and T4VEN bits in the timer interrupt
skipping set register (TITCR) are cleared to 0 or the skipping count set bits (3ACOR
and 4VCOR) in TITCR are cleared to 0), do not link A/D converter start requests with
interrupt skipping operation (clear the ITA3AE, ITA4VE, ITB3AE, and ITB4VE bits in the
timer A/D converter start request control register (TADCR) to 0).
3. If link with interrupt skipping is enabled while interrupt skipping is disabled, A/D
converter start requests will not be issued.
* Do not set to 1 when complementary PWM mode is not selected.
Table 10.29 Setting of Transfer Timing by Bits BF1 and BF0
Bit 7
Bit 6
BF1
BF0
Description
0
0
Does not transfer data from the cycle set buffer register to the cycle
set register.
0
1
Transfers data from the cycle set buffer register to the cycle set
register at the crest of the TCNT_4 count.*¹
1
0
Transfers data from the cycle set buffer register to the cycle set
register at the trough of the TCNT_4 count.*²
1
1
Transfers data from the cycle set buffer register to the cycle set
register at the crest and trough of the TCNT_4 count.*²
Notes: 1. Data is transferred from the cycle set buffer register to the cycle set register when the
crest of the TCNT_4 count is reached in complementary PWM mode, when compare
match occurs between TCNT_3 and TGRA_3 in reset-synchronized PWM mode, or
when compare match occurs between TCNT_4 and TGRA_4 in PWM mode 1 or
normal operation mode.
2. These settings are prohibited when complementary PWM mode is not selected.
Rev. 3.00 Jun. 18, 2008 Page 470 of 1160
REJ09B0191-0300