SH7641 Datasheet, PDF (519/1036 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7641 Series

Section 15 User Debugging Interface (H-UDI)
15.4.2 Reset Configuration
Table 15.4 Reset Configuration
ASEMD0*¹
RESETP
TRST
Chip State
H
L
L
Normal reset and H-UDI reset
H
Normal reset
H
L
H-UDI reset only
H
Normal operation
L
L
L
Reset hold*²
H
Normal reset
H
L
H-UDI reset only
H
Normal operation
Notes: 1. Performs normal mode and ASE mode settings
ASEMD0 = H, normal mode
ASEMD0 = L, ASE mode
2. In ASE mode, reset hold is entered if the TRST pin is driven low while the RESETP pin
is negated. In this state, the CPU does not start up. When TRST is driven high, H-UDI
operation is enabled, but the CPU does not start up. The reset hold state is cancelled
by the following:
Another RESETP assert (power-on reset)
15.4.3 TDO Output Timing
The timing of data output from the TDO is switched by the command type set in the SDIR. The
timing changes at the TCK falling edge when JTAG commands (EXTEST, CLAMP, HIGHZ,
SAMPLE/PRELOAD, IDCODE, and BYPASS) are set. This is a timing of the JTAG standard.
When the H-UDI commands (H-UDI reset negate, H-UDI reset assert, and H-UDI interrupt) are
set, TDO is output at the TCK rising edge earlier than the JTAG standard by a half cycle.
Rev. 4.00 Sep. 14, 2005 Page 469 of 982
REJ09B0023-0400