SH7641 Datasheet, PDF (474/1036 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7641 Series

Section 13 Direct Memory Access Controller (DMAC)
13.4 Operation
When there is a DMA transfer request, the DMAC starts the transfer according to the
predetermined channel priority order; when the transfer end conditions are satisfied, it ends the
transfer. Transfers can be requested in three modes: auto request, external request, and on-chip
module request. The dual address mode has direct address transfer mode and indirect address
transfer mode. In the bus mode, the burst mode or the cycle steal mode can be selected.
13.4.1 DMA Transfer Flow
After the DMA source address registers (SAR), DMA destination address registers (DAR), DMA
transfer count registers (DMATCR), DMA channel control registers (CHCR), DMA operation
register (DMAOR), and DMA extension resource selector (DMARS) are set, the DMAC transfers
data according to the following procedure:
1. Checks to see if transfer is enabled (DE = 1, DME = 1, TE = 0, AE = 0, NMIF = 0)
2. When a transfer request comes and transfer is enabled, the DMAC transfers 1 transfer unit of
data (depending on the TS0 and TS1 settings). For an auto request, the transfer begins
automatically when the DE bit and DME bit are set to 1. The DMATCR value will be
decrement for each transfer. The actual transfer flows vary by address mode and bus mode.
3. When the specified number of transfer have been completed (when DMATCR reaches 0), the
transfer ends normally. If the IE bit of the CHCR is set to 1 at this time, a DEI interrupt is sent
to the CPU.
4. When a NMI interrupt is generated, the transfer is aborted. Transfers are also aborted when the
DE bit of the CHCR or the DME bit of the DMAOR are changed to 0.
Rev. 4.00 Sep. 14, 2005 Page 424 of 982
REJ09B0023-0400