D12320VF25IV Datasheet, PDF (646/1304 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 14 Serial Communication Interface (SCI)
Bit 2—Transmit End (TEND): Indicates that there is no valid data in TDR when the last bit of
the transmit character is sent, and transmission has been ended.
The TEND flag is read-only and cannot be modified.
Bit 2
TEND
Description
0
[Clearing conditions]
• When 0 is written to TDRE after reading TDRE = 1
• When the DMAC^* or DTC is activated by a TXI interrupt and writes data to TDR
1
[Setting conditions]
(Initial value)
• When the TE bit in SCR is 0
• When TDRE = 1 at transmission of the last bit of a 1-byte serial transmit character
Note: * The DMAC is not supported in the H8S/2321.
Bit 1—Multiprocessor Bit (MPB): When reception is performed using multiprocessor format in
asynchronous mode, MPB stores the multiprocessor bit in the receive data.
MPB is a read-only bit, and cannot be modified.
Bit 1
MPB
Description
0
[Clearing condition]
When data with a 0 multiprocessor bit is received
(Initial value)^*
1
[Setting condition]
When data with a 1 multiprocessor bit is received
Note: * Retains its previous state when the RE bit in SCR is cleared to 0 with multiprocessor
format.
Bit 0—Multiprocessor Bit Transfer (MPBT): When transmission is performed using
multiprocessor format in asynchronous mode, MPBT stores the multiprocessor bit to be added to
the transmit data.
The MPBT bit setting is invalid when multiprocessor format is not used, when not transmitting,
and in synchronous mode.
Bit 0
MPBT
0
1
Description
Data with a 0 multiprocessor bit is transmitted
Data with a 1 multiprocessor bit is transmitted
(Initial value)
Rev.6.00 Sep. 27, 2007 Page 614 of 1268
REJ09B0220-0600