D12320VF25IV Datasheet, PDF (225/1304 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 6 Bus Controller
RAS Down Mode and RAS Up Mode: Even when burst operation is selected, it may happen that
access to DRAM space is not continuous, but is interrupted by access to another space. In this
case, if the RAS signal is held low during the access to the other space, burst operation can be
resumed when the same row address in DRAM space is accessed again.
• RAS down mode
To select RAS down mode, set the RCDM bit in MCR to 1. If access to DRAM space is
interrupted and another space is accessed, the RAS signal is held low during the access to the
other space, and burst access is performed if the row address of the next DRAM space access
is the same as the row address of the previous DRAM space access. Figure 6.21 shows an
example of the timing in RAS down mode.
Note, however, that the RAS signal will go high if a refresh operation interrupts RAS down
mode.
DRAM access
External space
access
DRAM access
T_p
T_r
T_c1
T_c2
T₁
T₂
T_c1
T_c2
φ
A₂₃ to A₀
CSn (RAS)
CAS, LCAS
D₁₅ to D₀
Note: n = 2 to 5
Figure 6.21 Example of Operation Timing in RAS Down Mode
Rev.6.00 Sep. 27, 2007 Page 193 of 1268
REJ09B0220-0600