D12320VF25IV Datasheet, PDF (553/1304 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 10 16-Bit Timer Pulse Unit (TPU)
10.7 Usage Notes
Note that the kinds of operation and contention described below can occur during TPU operation.
Input Clock Restrictions: The input clock pulse width must be at least 1.5 states in the case of
single-edge detection, and at least 2.5 states in the case of both-edge detection. The TPU will not
operate properly with a narrower pulse width.
In phase counting mode, the phase difference and overlap between the two input clocks must be at
least 1.5 states, and the pulse width must be at least 2.5 states. Figure 10.48 shows the input clock
conditions in phase counting mode.
TCLKA
(TCLKC)
TCLKB
(TCLKD)
Phase
Phase
differ-
differ-
Overlap ence Overlap ence
Pulse width
Pulse width
Pulse width
Pulse width
Notes: Phase difference and overlap : 1.5 states or more
Pulse width
: 2.5 states or more
Figure 10.48 Phase Difference, Overlap, and Pulse Width in Phase Counting Mode
Caution on Period Setting: When counter clearing by compare match is set, TCNT is cleared in
the final state in which it matches the TGR value (the point at which the count value matched by
TCNT is updated). Consequently, the actual counter frequency is given by the following formula:
φ
f=
(N + 1)
Where
f : Counter frequency
φ : Operating frequency
N : TGR set value
Rev.6.00 Sep. 27, 2007 Page 521 of 1268
REJ09B0220-0600