D12320VF25IV Datasheet, PDF (333/1304 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 7 DMA Controller (Not Supported in the H8S/2321)
7.5.15 NMI Interrupts and DMAC
When an NMI interrupt is requested, burst mode transfer in full address mode is interrupted. An
NMI interrupt does not affect the operation of the DMAC in other modes.
In full address mode, transfer is enabled for a channel when both the DTE bit and the DTME bit
are set to 1. With burst mode setting, the DTME bit is cleared when an NMI interrupt is requested.
If the DTME bit is cleared during burst mode transfer, the DMAC discontinues transfer on
completion of the 1-byte or 1-word transfer in progress, then releases the bus, which passes to the
CPU.
The channel on which transfer was interrupted can be restarted by setting the DTME bit to 1 again.
Figure 7.36 shows the procedure for continuing transfer when it has been interrupted by an NMI
interrupt on a channel designated for burst mode transfer.
Resumption of
transfer on interrupted
channel
DTE = 1
[1]
DTME = 0
No
Yes
Set DTME bit to 1
[2]
[1] Check that DTE = 1 and
DTME = 0 in DMABCRL.
[2] Write 1 to the DTME bit.
Transfer continues
Transfer ends
Figure 7.36 Example of Procedure for Continuing Transfer on Channel Interrupted by
NMI Interrupt
Rev.6.00 Sep. 27, 2007 Page 301 of 1268
REJ09B0220-0600