English
Language : 

D12320VF25IV Datasheet, PDF (246/1304 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents
Section 6 Bus Controller
As a refresh* and an external access by an internal bus master can be executed simultaneously,
there is no relative order of priority for these two operations.
Note: * The DMAC and DRAM interface are not supported in the H8S/2321.
6.11.3 Bus Transfer Timing
Even if a bus request is received from a bus master with a higher priority than that of the bus
master that has acquired the bus and is currently operating, the bus is not necessarily transferred
immediately. There are specific times at which each bus master can relinquish the bus.
CPU: The CPU is the lowest-priority bus master, and if a bus request is received from the DTC or
DMAC*, the bus arbiter transfers the bus to the bus master that issued the request. The timing for
transfer of the bus is as follows:
• The bus is transferred at a break between bus cycles. However, if a bus cycle is executed in
discrete operations, as in the case of a longword-size access, the bus is not transferred between
the operations. See appendix A.5, Bus States during Instruction Execution, for timings at
which the bus is not transferred.
• If the CPU is in sleep mode, it transfers the bus immediately.
DTC: The DTC sends the bus arbiter a request for the bus when an activation request is generated.
The DTC can release the bus after a vector read, a register information read (3 states), a single data
transfer, or a register information write (3 states). It does not release the bus during a register
information read (3 states), a single data transfer, or a register information write (3 states).
DMAC*: The DMAC sends the bus arbiter a request for the bus when an activation request is
generated.
In the case of an external request in short address mode or normal mode, and in cycle steal mode,
the DMAC releases the bus after a single transfer.
In block transfer mode, it releases the bus after transfer of one block, and in burst mode, after
completion of a transfer.
Note: * The DMAC is not supported in the H8S/2321.
Rev.6.00 Sep. 27, 2007 Page 214 of 1268
REJ09B0220-0600