D12320VF25IV Datasheet, PDF (266/1304 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 7 DMA Controller (Not Supported in the H8S/2321)
Bit 8—Data Transfer Acknowledge 0A (DTA0A): Enables or disables clearing, when DMA
transfer is performed, of the internal interrupt source selected by the channel 0A data transfer
factor setting.
Bit 8
DTA0A
0
1
Description
Clearing of selected internal interrupt source at time of DMA transfer is disabled
(Initial value)
Clearing of selected internal interrupt source at time of DMA transfer is enabled
Bits 7 to 4—Data Transfer Enable (DTE): When DTE = 0, data transfer is disabled and the
activation source selected by the data transfer factor setting is ignored. If the activation source is
an internal interrupt, an interrupt request is issued to the CPU or DTC. If the DTIE bit is set to 1
when DTE = 0, the DMAC regards this as indicating the end of a transfer, and issues a transfer
end interrupt request to the CPU or DTC.
The conditions for the DTE bit being cleared to 0 are as follows:
• When initialization is performed
• When the specified number of transfers have been completed in a transfer mode other than
repeat mode
• When 0 is written to the DTE bit to forcibly abort the transfer, or for a similar reason
When DTE = 1, data transfer is enabled and the DMAC waits for a request by the activation
source selected by the data transfer factor setting. When a request is issued by the activation
source, DMA transfer is executed.
The condition for the DTE bit being set to 1 is as follows:
• When 1 is written to the DTE bit after the DTE bit is read as 0
Bit 7—Data Transfer Enable 1B (DTE1B): Enables or disables data transfer on channel 1B.
Bit 7
DTE1B
0
1
Description
Data transfer disabled
Data transfer enabled
(Initial value)
Rev.6.00 Sep. 27, 2007 Page 234 of 1268
REJ09B0220-0600