EP4SE360F35I4 Datasheet, PDF (389/432 Pages) Altera Corporation – This section provides a complete overview of all features relating to the Stratix IV device family, which is the most architecturlly advanced

Chapter 10: Configuration, Design Security, and Remote System Upgrades in Stratix IV Devices
Remote System Upgrades
10–53
1 When using fast AS mode, you must select remote update mode in the Quartus II
software and insert the ALTREMOTE_UPDATE megafunction to access the circuitry.
For more information, refer to “ALTREMOTE_UPDATE Megafunction” on
page 10–62.
Enabling Remote Update
You can enable remote update for Stratix IV devices in the Quartus II software before
design compilation (in the Compiler Settings menu). In remote update mode, the
auto-restart configuration after error option is always enabled. To enable remote
update in the project’s compiler settings, in the Quartus II software, follow these
steps:
1. On the Assignment menu, click Device. The Settings dialog box appears.
2. Click Device and Pin Options. The Device and Pin Options dialog box appears.
3. Click the Configuration tab.
4. From the Configuration scheme list, select Active Serial (you can also use
Configuration Device) (Figure 10–23).
5. From the Configuration Mode list, select Remote (Figure 10–23).
6. Click OK.
7. In the Settings dialog box, click OK.
Figure 10–23. Enabling Remote Update for Stratix IV Devices in the Compiler Settings Menu
September 2012 Altera Corporation
Stratix IV Device Handbook
Volume 1