English
Language : 

EP2AGX95EF29C6N Datasheet, PDF (318/380 Pages) Altera Corporation – Device Interfaces and Integration
9–32
Chapter 9: Configuration, Design Security, and Remote System Upgrades in Arria II Devices
PS Configuration
Figure 9–15 shows how to configure multiple Arria II devices with a download cable.
Figure 9–15. Multi-Device PS Configuration Using a USB-Blaster, EthernetBlaster, EthernetBlaster II, or ByteBlaster II
Cable
VCCIO/VCCPGM
(1)
10 kΩ (2)
VCCIO/VCCPGM
(1)
10 kΩ
(3)
GND
Arria II Device 1
CONF_DONE
nSTATUS
MSEL[n..0]
DCLK
nCEO
nCE
VCCIO/VCCPGM
(1)
VCCIO/VCCPGM
10 kΩ
(1)
Download Cable
10-Pin Male Header
VCCIO/VCCPGM (PS Mode)
10 kΩ
(1)
10 kΩ (2)
Pin 1
VCCIO/VCCPGM
(1)
GND
VIO (4)
DATA0
nCONFIG
GND
Arria II Device 2
(3)
VCCIO/
VCCPGM(1)
CONF_DONE
MSEL[n..0] nSTATUS
DCLK
10 kΩ
nCE
nCEO N.C.
DATA0
nCONFIG
Notes to Figure 9–15:
(1) Connect the pull-up resistor to the same supply voltage, VCCIO for Arria II GX devices or VCCPGM for Arria II GZ devices as the USB-Blaster,
EthernetBlaster, EthernetBlaster II, or ByteBlaster II cable.
(2) You only need the pull-up resistors on DATA0 and DCLK if the download cable is the only configuration scheme used on your board. This ensures
that DATA0 and DCLK are not left floating after configuration. For example, if you are also using a configuration device, you do not need the pull-up
resistors on DATA0 and DCLK.
(3) The MSEL pin settings vary for different configuration voltage standards and POR delays. To connect MSEL[3..0]for an Arria II GX device, refer
to Table 9–6 on page 9–9. To connect MSEL[2..0] for an Arria II GZ device, refer to Table 9–7 on page 9–10.
(4) In the USB-Blaster and ByteBlaster II cables, this pin is connected to nCE when it is used for AS programming; otherwise, it is a no connect.
f For more information about how to use the USB-Blaster, ByteBlaster II,
EthernetBlaster, or EthernetBlaster II cables, refer to the following user guides:
■ ByteBlaster II Download Cable User Guide
■ EthernetBlaster Communications Cable User Guide
■ EthernetBlaster II Communications Cable User Guide
■ USB-Blaster Download Cable User Guide
Arria II Device Handbook Volume 1: Device Interfaces and Integration
July 2012 Altera Corporation