SH7750_08 Datasheet, PDF (217/1162 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

Section 4 Caches
In the address field, bits [31:24] have the value H'F1 indicating the IC data array, and the entry is
specified by bits [12:5]. CCR.IIX has no effect on this entry specification. Address field bits [4:2]
are used for the longword data specification in the entry. As only longword access is used, 0
should be specified for address field bits [1:0].
The data field is used for the longword data specification.
The following two kinds of operation can be used on the IC data array:
1. IC data array read
Longword data is read into the data field from the data specified by the longword specification
bits in the address field in the IC entry corresponding to the entry set in the address field.
2. IC data array write
The longword data specified in the data field is written for the data specified by the longword
specification bits in the address field in the IC entry corresponding to the entry set in the
address field.
31
24 23
Address field _{1 1 1 1 0 0 0 1}
13 12
Entry
54 210
L
31
0
Data field
Longword data
Legend:
L: Longword specification bits
: Reserved bits (0 write value, undefined read value)
Figure 4.9 Memory-Mapped IC Data Array
4.5.3 OC Address Array
The OC address array is allocated to addresses H'F400 0000 to H'F4FF FFFF in the P4 area. An
address array access requires a 32-bit address field specification (when reading or writing) and a
32-bit data field specification. The entry to be accessed is specified in the address field, and the
write tag, U bit, and V bit are specified in the data field.
In the address field, bits [31:24] have the value H'F4 indicating the OC address array, and the
entry is specified by bits [13:5]. CCR.OIX and CCR.ORA have no effect on this entry
specification. The address array bit [3] association bit (A bit) specifies whether or not association
Rev.7.00 Oct. 10, 2008 Page 133 of 1074
REJ09B0366-0700