PIC16LF18854 Datasheet, PDF (446/668 Pages) Microchip Technology – C Compiler Optimized RISC Architecture

PIC16(L)F18856/76
30.0 CAPTURE/COMPARE/PWM
MODULES
The Capture/Compare/PWM module is a peripheral
that allows the user to time and control different events,
and to generate Pulse-Width Modulation (PWM)
signals. In Capture mode, the peripheral allows the
timing of the duration of an event. The Compare mode
allows the user to trigger an external event when a
predetermined amount of time has expired. The PWM
mode can generate Pulse-Width Modulated signals of
varying frequency and duty cycle.
The Capture/Compare/PWM modules available are
shown in Table 30-1.
TABLE 30-1: AVAILABLE CCP MODULES
Device
CCP1 CCP2 CCP3 CCP4 CCP5
PIC16(L)F18856/76
●
●
●
●
●
The Capture and Compare functions are identical for all
CCP modules.
Note 1: In devices with more than one CCP
module, it is very important to pay close
attention to the register names used. A
number placed after the module acronym
is used to distinguish between separate
modules. For example, the CCP1CON
and CCP2CON control the same
operational aspects of two completely
different CCP modules.
2: Throughout this section, generic
references to a CCP module in any of its
operating modes may be interpreted as
being equally applicable to CCPx module.
Register names, module signals, I/O pins,
and bit names may use the generic
designator ‘x’ to indicate the use of a
numeral to distinguish a particular module,
when required.
DS40001824A-page 446
Preliminary
 2016 Microchip Technology Inc.