PIC16LF18854 Datasheet, PDF (438/668 Pages) Microchip Technology – C Compiler Optimized RISC Architecture

PIC16(L)F18856/76
29.5.10 LEVEL-TRIGGERED HARDWARE
LIMIT ONE-SHOT MODES
The Level-Triggered Hardware Limit One-Shot modes
hold the timer in Reset on an external Reset level and
start counting when both the ON bit is set and the exter-
nal signal is not at the Reset level. If one of either the
external signal is not in Reset or the ON bit is set then
the other signal being set/made active will start the
timer. Reset levels are selected as follows:
• Low Reset level (MODE<4:0> = 10110)
• High Reset level (MODE<4:0> = 10111)
When the timer count matches the PRx period count,
the timer is reset and the ON bit is cleared. When the
ON bit is cleared by either a PRx match or by software
control the timer will stay in Reset until both the ON bit
is set and the external signal is not at the Reset level.
When Level-Triggered Hardware Limit One-Shot
modes are used in conjunction with the CCP PWM
operation the PWM drive goes active with either the
external signal edge or the setting of the ON bit, which-
ever of the two starts the timer.
DS40001824A-page 438
Preliminary
 2016 Microchip Technology Inc.