PIC16LF18854 Datasheet, PDF (219/668 Pages) Microchip Technology – C Compiler Optimized RISC Architecture

PIC16(L)F18856/76
REGISTER 12-25: ANSELC: PORTC ANALOG SELECT REGISTER
R/W-1/1
ANSC7
bit 7
R/W-1/1
ANSC6
R/W-1/1
ANSC5
R/W-1/1
ANSC4
R/W-1/1
ANSC3
R/W-1/1
ANSC2
R/W-1/1
ANSC1
R/W-1/1
ANSC0
bit 0
Legend:
R = Readable bit
u = Bit is unchanged
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
bit 7-0
ANSC<7:0>: Analog Select between Analog or Digital Function on Pins RC<7:0>, respectively⁽¹⁾
0 = Digital I/O. Pin is assigned to port or digital special function.
1 = Analog input. Pin is assigned as analog input⁽¹⁾. Digital input buffer disabled.
Note 1: When setting a pin to an analog input, the corresponding TRIS bit must be set to Input mode in order to
allow external control of the voltage on the pin.
REGISTER 12-26: WPUC: WEAK PULL-UP PORTC REGISTER
R/W-0/0
WPUC7
bit 7
R/W-0/0
WPUC6
R/W-0/0
WPUC5
R/W-0/0
WPUC4
R/W-0/0
WPUC3
R/W-0/0
WPUC2
R/W-0/0
WPUC1
R/W-0/0
WPUC0
bit 0
Legend:
R = Readable bit
u = Bit is unchanged
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
bit 7-0
WPUC<7:0>: Weak Pull-up Register bits⁽¹⁾
1 = Pull-up enabled
0 = Pull-up disabled
Note 1: The weak pull-up device is automatically disabled if the pin is configured as an output.
 2016 Microchip Technology Inc.
Preliminary
DS40001824A-page 219