PIC16LF18854 Datasheet, PDF (309/668 Pages) Microchip Technology – C Compiler Optimized RISC Architecture

PIC16(L)F18856/76
REGISTER 20-5: CWGxAS0: CWGx AUTO-SHUTDOWN CONTROL REGISTER 0
R/W/HS-0/0
R/W-0/0
R/W-0/0
R/W-1/1
R/W-0/0
R/W-1/1
U-0
SHUTDOWN^{(1, 2)}
REN
LSBD<1:0>
LSAC<1:0>
—
bit 7
U-0
—
bit 0
Legend:
HC = Bit is cleared by hardware
R = Readable bit
W = Writable bit
u = Bit is unchanged
x = Bit is unknown
‘1’ = Bit is set
‘0’ = Bit is cleared
HS = Bit is set by hardware
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
q = Value depends on condition
bit 7
bit 6
bit 5-4
bit 3-2
bit 1-0
SHUTDOWN: Auto-Shutdown Event Status bit^{(1, 2)}
1 = An Auto-Shutdown state is in effect
0 = No Auto-shutdown event has occurred
REN: Auto-Restart Enable bit
1 = Auto-restart enabled
0 = Auto-restart disabled
LSBD<1:0>: CWGxB and CWGxD Auto-Shutdown State Control bits
11 = A logic ‘1’ is placed on CWGxB/D when an auto-shutdown event is present
10 = A logic ‘0’ is placed on CWGxB/D when an auto-shutdown event is present
01 = Pin is tri-stated on CWGxB/D when an auto-shutdown event is present
00 = The inactive state of the pin, including polarity, is placed on CWGxB/D after the required
dead-band interval
LSAC<1:0>: CWGxA and CWGxC Auto-Shutdown State Control bits
11 = A logic ‘1’ is placed on CWGxA/C when an auto-shutdown event is present
10 = A logic ‘0’ is placed on CWGxA/C when an auto-shutdown event is present
01 = Pin is tri-stated on CWGxA/C when an auto-shutdown event is present
00 = The inactive state of the pin, including polarity, is placed on CWGxA/C after the required
dead-band interval
Unimplemented: Read as ‘0’
Note 1: This bit may be written while EN = 0 (CWGxCON0 register) to place the outputs into the shutdown config-
uration.
2: The outputs will remain in auto-shutdown state until the next rising edge of the input signal after this bit is
cleared.
 2016 Microchip Technology Inc.
Preliminary
DS40001824A-page 309