SH7729R Datasheet, PDF (73/855 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

31
28 27 16 15 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 MD RB BL RC^*
0-0 DSP^*DMY^*DMX^*M Q I3 I2 I1 I0 RF1^*RF0^* S T
SR (Status register)
MD bit:
Processing mode bit
MD = 1: Privileged mode
MD = 0: User mode
RB bit:
Register bank bit; used to define the general registers in privileged mode.
RB = 1: R0_BANK1 to R7_BANK1 are used as general registers.
R0_BANK0 to R7_BANK0 accessed by LDC/STC instructions.
RB = 0: R0_BANK0 to R7_BANK0 are used as general registers.
R0_BANK1 to R7_BANK1 accessed by LDC/STC instructions.
BL bit:
Block bit; used to mask exception in privileged mode.
BL = 1: Interrupts are masked (not accepted)
BL = 0: Interrupts are accepted
RC [11:0]: 12-bit repeat counter
DSP bit:
DSP operation mode
DSP = 1: DSP instructions (LDS Rm, DSR/A0/X0/X1/Y0/Y1,
LDS.L @Rm+, DSR/A0/X0/X1/Y0/Y1,
STS DSR/A0/X0/X1/Y0/Y1, Rn,
STS.L DSR/A0/X0/X1/Y0/Y1, @−Rn,
LDC Rm, RS/RE/MOD,
LDC.L @Rm+, RS/RE/MOD,
STC RS/RE/MOD,Rn,
STC.L RS/RE/MOD, @−Rn,
LDRS, LDRE, SETRC, MOVS, MOVX, MOVY,
Pxxx) are enabled.
DSP = 0: All DSP instructions are treated as illegal instructions; only SH3 instructions are
supported.
DMY bit: Modulo addressing enable for Y side
DMX bit: Modulo addressing enable for X side
Q, M bit: Used by DIV0U/S and DIV1 instructions.
I [3:0]: 4-bit field indicating the interrupt request mask level.
RF [1:0]: Used for repeat control
S bit:
Used by the MAC instructions and DSP data.
T bit:
The MOVT, CMP/cond, TAS.TST, BT, BF, SETT, CLRT and DT instructions use the T bit to
indicate true (logic one) or false (logic zero). The ADDV/C, SUBV/C, DIV0U/S, DIV1,
NEGC, SHAR/L, SHLR/L, ROTR/L and ROTCR/L instructions also use the T bit to indicate
a carry, borrow, overflow, or underflow.
Reserved bits [bit31, bits15 to 13]: Always read as 0, and should always be written with 0.
*:
Used in DSP mode.
Figure 2.5 Control Registers
Rev. 5.0, 09/03, page 27 of 806