SH7729R Datasheet, PDF (64/855 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

Pin No.
FP-208C,
FP-208E BP-240A Pin Name
I/O
Description
201
C5
AN[2]/PTL[2]
I
A/D converter input / input port L
202
D4
AN[3]/PTL[3]
I
A/D converter input / input port L
203
A5
AN[4]/PTL[4]
I
A/D converter input / input port L
204
C4
AN[5]/PTL[5]
I
A/D converter input / input port L
205
A4
AVcc
—
Analog power supply (3.3 V)
206
B5
AN[6]/DA[1]/PTL[6]
I
A/D converter input / input port L
207
B3
AN[7]/DA[0]/PTL[7]
I
A/D converter input / input port L
208
B4
AVss
—
Analog power supply (0 V)
Notes: 1. Must be connected to the power supply even when the RTC is not used.
2. Except in hardware standby mode, all power supply pins must be connected to the
system power supply. (Supply power constantly.) In hardware standby mode, power
must be supplied at least to VCC–RTC and VSS–RTC. If power is not supplied to power
supply pins other than VCC–RTC and VSS–RTC, hold the CA pin low.
3. 2.0 V in 200 MHz models, 1.9 V in 167 MHz models, 1.8 V in 133 MHz models, 1.7 V in
100 MHz models.
4. Drive high when using the user system alone, and not using an emulator or the UDI.
When this pin is low or open, RESETP may be masked (see section 23 User
Debugging Interface (UDI)).
5. B2, B1, C1, U1, V1, W1, V2, W2, W3, W17, W18, W19, V18, V19, B19, A19, B18, A18,
A17, A3, A2, and A1 are NC pins. No connection should be made to these pins.
6. If EXTAL2 is not used, pull this pin up to the Vcc-RTC level.
Rev. 5.0, 09/03, page 18 of 806