SH7729R Datasheet, PDF (450/855 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

• Burst Mode
Once the bus is obtained, the transfer is performed continuously until the transfer end
condition is satisfied. In external request mode with low level detection of the DREQ pin,
however, when the DREQ pin is driven high, the bus passes to the other bus master after the
DMAC transfer request that has already been accepted ends, even if the transfer end conditions
have not been satisfied.
Burst mode cannot be used when a SCIF (IrDA or SCIF) is the transfer request source. Figure
12.15 shows an example of burst mode timing.
DREQ
Bus cycle
CPU
CPU CPU DMAC DMAC DMAC DMAC DMAC DMAC CPU
Read Write Read Write Read Write
Figure 12.15 Example of Transfer in Burst Mode
Rev. 5.0, 09/03, page 404 of 806