SH7729R Datasheet, PDF (474/855 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

12.5.2 Example of DMA Transfer between A/D Converter and External Memory
(Address Reload On)
In this example, DMA transfer is performed between the on-chip A/D converter (transfer source)
and the external memory (transfer destination) with the address reload function on. Table 12.9
shows the transfer conditions and register settings.
Table 12.9 Transfer Conditions and Register Settings for Transfer between On-Chip A/D
Converter and External Memory
Transfer Conditions
Transfer source: On-chip A/D converter
Transfer destination: External memory
Number of transfers: 128 (reloading 32 times)
Transfer source address: Incremented
Transfer destination address: Decremented
Transfer request source: A/D converter
Bus mode: Burst
Transfer unit: Longword
Interrupt request generated at end of transfer
Channel priority order: 0 > 2 > 3 > 1
Register
SAR2
DAR2
DMATCR2
CHCR2
Setting
H'04000080
H'00400000
H'00000080
H'00089E35
DMAOR
H'0101
When the address reload function is on, the value set in SAR returns to the initially set value every
four transfers. In this example, when an interrupt request is generated from the A/D converter,
byte data is read from the register at address H'04000080 in the A/D converter, and is written to
external memory address H'00400000. Since longword data has been transferred, the values in
SAR and DAR are H'04000084 and H'003FFFFC, respectively. The bus is kept and data transfers
are performed successively because this transfer is in burst mode.
After four transfers end, fifth and sixth transfers are performed if the address reload function is off,
and the value in SAR is incremented from H'0400008C to H'04000090, H'04000094… If the
address reload function is on, DMA transfer stops after the fourth transfer ends, and the bus
request signal to the CPU is cleared. At this time, the value stored in SAR is not incremented
from H'0400008C to H'04000090, but returns to the initially set value, H'04000080. The value in
DAR continues to be incremented regardless of whether the address reload function is on or off.
Rev. 5.0, 09/03, page 428 of 806