SH7080 Datasheet, PDF (854/1644 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 16 Serial Communication Interface with FIFO (SCIF)
Initial
Bit
Bit Name value R/W Description
4
O/E
0
R/W Parity mode
Selects even or odd parity when parity bits are added
and checked. The O/E setting is used only in
asynchronous mode and only when the parity enable bit
(PE) is set to 1 to enable parity addition and checking.
The O/E setting is ignored in clock synchronous mode,
or in asynchronous mode when parity addition and
checking is disabled.
0: Even parity*¹
1: Odd parity*²
Note: 1. If even parity is selected, the parity bit is
added to transmit data to make an even
number of 1s in the transmitted character and
parity bit combined. Receive data is checked
to see if it has an even number of 1s in the
received character and parity bit combined.
2. If odd parity is selected, the parity bit is
added to transmit data to make an odd
number of 1s in the transmitted character and
parity bit combined. Receive data is checked
to see if it has an odd number of 1s in the
received character and parity bit combined.
3
STOP
0
R/W Stop Bit Length
Selects one or two bits as the stop bit length in
asynchronous mode. This setting is used only in
asynchronous mode. It is ignored in clock synchronous
mode because no stop bits are added.
When receiving, only the first stop bit is checked,
regardless of the STOP bit setting. If the second stop
bit is 1, it is treated as a stop bit, but if the second stop
bit is 0, it is treated as the start bit of the next incoming
character.
0: One stop bit
When transmitting, a single 1-bit is added at the end
of each transmitted character.
1: Two stop bits
When transmitting, two 1 bits are added at the end of
each transmitted character.
Rev. 3.00 May 17, 2007 Page 796 of 1582
REJ09B0181-0300