SH7080 Datasheet, PDF (586/1644 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 11 Multi-Function Timer Pulse Unit 2 (MTU2)
Table 11.45 shows the TICCR setting and input capture input pins.
Table 11.45 TICCR Setting and Input Capture Input Pins
Target Input Capture
Input capture from TCNT_1 to
TGRA_1
Input capture from TCNT_1 to
TGRB_1
Input capture from TCNT_2 to
TGRA_2
Input capture from TCNT_2 to
TGRB_2
TICCR Setting
I2AE bit = 0 (initial value)
I2AE bit = 1
I2BE bit = 0 (initial value)
I2BE bit = 1
I1AE bit = 0 (initial value)
I1AE bit = 1
I1BE bit = 0 (initial value)
I1BE bit = 1
Input Capture Input Pins
TIOC1A
TIOC1A, TIOC2A
TIOC1B
TIOC1B, TIOC2B
TIOC2A
TIOC2A, TIOC1A
TIOC2B
TIOC2B, TIOC1B
Example of Cascaded Operation Setting Procedure: Figure 11.20 shows an example of the
setting procedure for cascaded operation.
Cascaded operation
Set cascading
[1]
Start count
[2]
[1] Set bits TPSC2 to TPSC0 in the channel 1
TCR to B'1111 to select TCNT_2 overflow/
underflow counting.
[2] Set the CST bit in TSTR for the upper and
lower channel to 1 to start the count
operation.
<Cascaded operation>
Figure 11.20 Cascaded Operation Setting Procedure
Cascaded Operation Example (a): Figure 11.21 illustrates the operation when TCNT_2
overflow/underflow counting has been set for TCNT_1 and phase counting mode has been
designated for channel 2.
TCNT_1 is incremented by TCNT_2 overflow and decremented by TCNT_2 underflow.
Rev. 3.00 May 17, 2007 Page 528 of 1582
REJ09B0181-0300