SH7080 Datasheet, PDF (212/1644 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 7 User Break Controller (UBC)
Initial
Bit
Bit Name Value R/W Description
3
SEQ
0
R/W Sequence Condition Select
Selects two conditions of channels A and B as
independent or sequential conditions.
0: Channels A and B are compared under independent
conditions
1: Channels A and B are compared under sequential
conditions (channel A, then channel B)
2, 1

All 0
R
Reserved
These bits are always read as 0. The write value
should always be 0.
0
ETBE
0
R/W Number of Execution Times Break Enable
Enables the execution-times break condition only on
channel B. If this bit is 1 (break enable), a user break
interrupt is requested when the number of break
conditions matches with the number of execution times
that is specified by BETR.
0: The execution-times break condition is disabled on
channel B
1: The execution-times break condition is enabled on
channel B
Rev. 3.00 May 17, 2007 Page 154 of 1582
REJ09B0181-0300