SH7080 Datasheet, PDF (156/1644 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 5 Exception Handling
5.5.3 Illegal Slot Instructions
An instruction placed immediately after a delayed branch instruction is called "instruction placed
in a delay slot". When the instruction placed in the delay slot is an undefined code, illegal slot
exception handling starts after the undefined code is decoded. Illegal slot exception handling also
starts when an instruction that changes the program counter (PC) value is placed in a delay slot
and the instruction is decoded. The CPU handles an illegal slot instruction as follows:
1. The status register (SR) is saved to the stack.
2. The program counter (PC) is saved to the stack. The PC value saved is the target address of the
delayed branch instruction immediately before the undefined code or the instruction that
rewrites the PC.
3. The start address of the exception handling routine is fetched from the exception handling
vector table that corresponds to the exception that occurred. Program execution branches to
that address and the program starts. This branch is not a delayed branch.
5.5.4 General Illegal Instructions
When an undefined code placed anywhere other than immediately after a delayed branch
instruction (i.e., in a delay slot) is decoded, general illegal instruction exception handling starts.
The CPU handles the general illegal instructions in the same procedures as in the illegal slot
instructions. Unlike processing of illegal slot instructions, however, the program counter value that
is stacked is the start address of the undefined code.
Rev. 3.00 May 17, 2007 Page 98 of 1582
REJ09B0181-0300