SH7080 Datasheet, PDF (791/1644 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 15 Serial Communication Interface (SCI)
Initial
Bit
Bit Name value R/W Description
2
TEIE
0
R/W Transmit End Interrupt Enable
Enables or disables a transmit end interrupt (TEI) to be
issued when no valid transmit data is found in SCTDR
during MSB data transmission.
TEI can be canceled by clearing the TEND flag to 0 (by
clearing the TDRE flag in SCSSR to 0 after reading
TDRE = 1) or by clearing the TEIE bit to 0.
0: Transmit end interrupt request (TEI) is disabled
1: Transmit end interrupt request (TEI) is enabled
1, 0
CKE[1:0] 00
R/W Clock Enable 1 and 0
Select the SCI clock source and enable or disable clock
output from the SCK pin. Depending on the
combination of CKE1 and CKE0, the SCK pin can be
used for serial clock output or serial clock input.
When selecting the clock output in clock synchronous
mode, set the C/A bit in SCSMR to 1 and then set bits
CKE1 and CKE0. For details on clock source selection,
refer to table 15.14 in section 15.4, Operation.
• Asynchronous mode
00: Internal clock, SCK pin used for input pin (The input
signal is ignored.)
01: Internal clock, SCK pin used for clock output*¹
10: External clock, SCK pin used for clock input*²
11: External clock, SCK pin used for clock input*²
• Clock synchronous mode
00: Internal clock, SCK pin used for synchronous clock
output
01: Internal clock, SCK pin used for synchronous clock
output
10: External clock, SCK pin used for synchronous clock
input
11: External clock, SCK pin used for synchronous clock
input
Notes: 1. The output clock frequency is 16 times the
bit rate.
2. The input clock frequency is 16 times the bit
rate.
Rev. 3.00 May 17, 2007 Page 733 of 1582
REJ09B0181-0300