SH7080 Datasheet, PDF (1165/1644 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 21 Pin Function Controller (PFC)
Initial
Bit
Bit Name Value R/W Description
1
PD12MD1 0
R/W PD12 Mode
0
PD12MD0 0*¹
R/W Select the function of the PD12/D12/TIOC4AS pin.
00: PD12 I/O (port)
01: D12 I/O (BSC)*²
11: TIOC4AS I/O (MTU2S)
Other than above: Setting prohibited
Notes: 1. The initial value is 1 in the on-chip ROM disabled 16-bit external-extension mode.
2. This function is enabled only in the on-chip ROM enabled/disabled external-extension
mode. Do not set 1 in single-chip mode.
• Port D Control Register L3 (PDCRL3)
Bit: 15
-
Initial value: 0
R/W: R
14 13 12 11 10 9
8
7
6
5
4
3
2
1
0
-
PD11 PD11
MD1 MD0
-
PD10 PD10 PD10
MD2 MD1 MD0
-
PD9 PD9 PD9
MD2 MD1 MD0
-
PD8 PD8 PD8
MD2 MD1 MD0
0
0 0*¹ 0
0
0 0*¹ 0
0
0 0*¹ 0
0
0 0*¹
R R/W R/W R R/W R/W R/W R R/W R/W R/W R R/W R/W R/W
Note: 1. The initial value is 1 in the on-chip ROM disabled 16-bit external-extension mode.
Initial
Bit
Bit Name Value R/W Description
15, 14 
All 0
R
Reserved
These bits are always read as 0. The write value
should always be 0.
13
PD11MD1 0
R/W PD11 Mode
12
PD11MD0 0*¹
R/W Select the function of the
PD11/D11/TIOC3DS/AUDATA3 pin. Fixed to
AUDATA3 output when using the AUD function of the
E10A.
00: PD11 I/O (port)
01: D11 I/O (BSC)*²
11: TIOC3DS I/O (MTU2S)
Other than above: Setting prohibited
11

0
R
Reserved
This bit is always read as 0. The write value should
always be 0.
Rev. 3.00 May 17, 2007 Page 1107 of 1582
REJ09B0181-0300