HD6417706 Datasheet, PDF (619/709 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

Item
Symbol Min Typ Max Unit Measurement Conditions
Analog During A/D AIcc
—
0.8 2
mA
power- conversion
supply
During A/D
—
2.4 6
mA
current and D/A
conversion
Idle
—
0.01 5.0 µA Ta = 25°C
Notes: Regardless of whether PLL or RTC is used, connect Vcc – PLL and Vcc – RTC to Vcc, and
Vss – PLL and Vss – RTC to Vss.
AVcc must be under condition of VccQ – 0.3 V ≤ AVcc ≤ VccQ + 0.3 V. If the A/D and D/A
converters are not used, do not leave the AVcc and AVss pins open. Connect AVcc to
VccQ, and connect AVss to VssQ.
Current dissipation values shown are the values at which all output pins are without load
under conditions of VIHmin = VccQ – 0.5 V, VILmax = 0.5 V.
1. No external bus cycles except refresh cycles.
2. Total current of Vcc, Vcc – PLL1, and Vcc – PLL2
3. Current of VccQ
4. Current of Vcc – RTC
5. Only in software standby mode
Table 24.3 Permitted Output Current Values
(VccQ = 3.3 ± 0.3 V, Vcc = 1.9 ± 0.15 V, AVcc = 3.3 ± 0.3 V, Ta = –20 to 75°C)
Item
Symbol
Min Typ Max Unit
Output low-level permissible current (per pin)
IOL
—
— 2.0 mA
Output low-level permissible current (total)
∑ IOL
—
— 120 mA
Output high-level permissible current (per pin)
–IOH
—
— 2.0 mA
Output high-level permissible current (total)
∑ (–IOH)
—
— 40 mA
Caution: To ensure LSI reliability, do not exceed the value for output current given in Table 24.3.
Rev. 4.00, 03/04, page 573 of 660