HD6417706 Datasheet, PDF (388/709 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

13.4.3 Reading the Time
Figure 13.3 shows how to read the time. If a carry occurs while reading the time, the correct time
will not be obtained, so it must be read again. Part (a) in figure 13.3 shows the method of reading
the time without using interrupts; part (b) in figure 13.3 shows the method using carry interrupts.
To keep programming simple, method (a) should normally be used.
(a) To read the time
without using interrupts
Disable the carry
interrupt
Write 0 to CIE in RCR1
Clear the carry flag
Read counter
register
Write 0 to CF in RCR1
Note: Set AF in RCR1 to 1 so that
alarm flag is not cleared.
Yes
Carry flag = 1?
Read RCR1 and check CF
No
(b) To use interrupts
Enable the carry
interrupt
Clear the carry flag
Read counter
register
Write 1 to CIE in RCR1,
and write 0 to CF in RCR1
Note: Set AF in RCR1 to 1 so that
alarm flag is not cleared.
Yes
Interrupt
generated?
No
Disable the carry
interrupt
Write 0 to CIE in RCR1
Figure 13.3 Reading the Time
Rev. 4.00, 03/04, page 342 of 660