HD6417706 Datasheet, PDF (196/709 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

When the data value is included in the break conditions, either longword, word, or byte is
specified as the operand size of the break bus cycle registers (BBRA and BBRB). When data
values are included in break conditions, a break is generated when the address conditions and
data conditions both match. To specify byte data for this case, set the same data in two bytes at
bits 15 to 8 and bits 7 to 0 of the break data register B (BDRB) and break data mask register B
(BDMRB). When word or byte is set, bits 31 to 16 of BDRB and BDMRB are ignored.
4. When the DMAC data access is included in the break condition:
When the address is included in the break condition on DMAC data access, the operand size of
the break bus cycle registers (BBRA and BBRB) should be byte, word or no specified operand
size. When the data value is included, select either byte or word.
7.3.4 Sequential Break
1. By specifying SEQ in BRCR is set to 1, the sequential break is issued when channel B break
condition matches after channel A break condition matches. A user break is ignored even if
channel B break condition matches before channel A break condition matches. When channels
A and B condition match at the same time, the sequential break is not issued.
2. In sequential break specification, logical or internal bus can be selected and the execution
times break condition can be also specified. For example, when the execution times break
condition is specified, the break condition is satisfied at channel B condition match with BETR
= H'0001 after channel A condition match.
7.3.5 Value of Saved Program Counter
The PC when a break occurs is saved to the SPC in user breaks. The PC value saved is as follows
depending on the type of break.
1. When instruction fetch (before instruction execution) is specified as a break condition:
The value of the program counter (PC) saved is the address of the instruction that matches the
break condition. The fetched instruction is not executed, and a break occurs before it.
2. When instruction fetch (after instruction execution) is specified as a break condition:
The PC value saved is the address of the instruction to be executed following the instruction in
which the break condition matches. The fetched instruction is executed, and a break occurs
before the execution of the next instruction.
3. When data access (address only) is specified as a break condition:
The PC value is the address of the instruction to be executed following the instruction that
matched the break condition. The instruction that matched the condition is executed and the
break occurs before the next instruction is executed.
4. When data access (address + data) is specified as a break condition:
Rev. 4.00, 03/04, page 150 of 660