SH7058 Datasheet, PDF (994/1130 Pages) Renesas Technology Corp – Renesas SuperHTM RISC engine

25.5 Sleep Mode
25.5.1 Transition to Sleep Mode
Executing the SLEEP instruction after the software standby bit (SSBY) in SBYCR has been
cleared to 0 causes a transition from the program execution state to sleep mode. Although the CPU
halts immediately after executing the SLEEP instruction, the contents of its internal registers
remain unchanged. The on-chip peripheral modules continue to run during sleep mode.
25.5.2 Canceling Sleep Mode
Cancellation by Interrupt: When an interrupt occurs, sleep mode is canceled and interrupt
exception processing is executed. The sleep mode is not canceled if the interrupt cannot be
accepted because its priority level is equal to or less than the mask level set in the CPU’s status
register (SR) or if an interrupt by an on-chip peripheral module is disabled by the peripheral
module.
Cancellation by DMA Address Error: If a DMA address error occurs, sleep mode is canceled
and DMA address error exception processing is executed.
Cancellation by Manual Reset: When an internal manual reset is triggered by the WDT and the
CPU acquires the bus during the internal manual reset period, the state of the SH7058 changes to
the manual reset state and sleep mode will be released.
Cancellation by Power-On Reset: A power-on reset of the SH7058 resulting from driving the
RES pin low, or caused by the WDT, cancels sleep mode.
Rev. 3.0, 09/04, page 953 of 1086