SH7058 Datasheet, PDF (520/1130 Pages) Renesas Technology Corp – Renesas SuperHTM RISC engine

• Bit 2—Transmit End (TEND): Indicates that when the last bit of a serial character was
transmitted, TDR did not contain valid data, so transmission has ended. TEND is a read-only
bit and cannot be written.
Bit 2: TEND
0
Description
Transmission is in progress
[Clearing conditions]
• When 0 is written to TDRE after reading TDRE = 1
• When the DMAC writes data in TDR
1
End of transmission
(Initial value)
[Setting conditions]
• Power-on reset, hardware standby mode, or software standby mode
• When the TE bit in SCR is 0
• If TDRE = 1 when the last bit of a one-byte serial transmit character is
transmitted
• Bit 1—Multiprocessor Bit (MPB): Stores the value of the multiprocessor bit in receive data
when a multiprocessor format is selected for receiving in asynchronous mode. MPB is a read-
only bit and cannot be written.
Bit 1: MPB
0
1
Description
Multiprocessor bit value in receive data is 0
(Initial value)
If RE is cleared to 0 when a multiprocessor format is selected, the MPB retains
its previous†value.
Multiprocessor bit value in receive data is 1
• Bit 0—Multiprocessor Bit Transfer (MPBT): Stores the value of the multiprocessor bit added
to transmit data when a multiprocessor format is selected for transmitting in asynchronous
mode. The MPBT setting is ignored in synchronous mode, when a multiprocessor format is not
selected, or when the SCI is not transmitting.
Bit 0: MPBT
0
1
Description
Multiprocessor bit value in transmit data is 0
Multiprocessor bit value in transmit data is 1
(Initial value)
Rev. 3.0, 09/04, page 479 of 1086