SH7032 Datasheet, PDF (450/687 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

Section 14 A/D Converter
14.4.3 Input Sampling Time and A/D Conversion Time
With a built-in sample-and-hold circuit, the A/D converter performs input sampling at time t_D
after control/status register (ADSCR) access is started. See figure 14.5 for A/D conversion timing
and table 14.4 for A/D conversion times.
The total conversion time includes t_D and the input sampling time, as shown in figure 14.5. The
purpose of t_D is to synchronize the ADCSR write time with the A/D conversion process; therefore
the duration of t_D is variable. As a result, the total conversion time varies within the ranges shown
in table 14.4.
In scan mode, the ranges given in table 14.4 apply to the first conversion. The duration of the
second and subsequent conversion processes is fixed at 256 states (CKS = 0) or 128 states (CKS =
1).
*1
CK
Address *2
Write
signal
Input sampling
timing
ADF
t_D
t_SPL
t_CONV
t_D A/D start delay
t_SPL Input sampling time
t_CONV A/D conversion time
Notes: 1. ADSCR write cycle
2. ADSCR address
Figure 14.5 A/D Conversion Timing
Rev. 7.00 Jan 31, 2006 page 424 of 658
REJ09B0272-0700