English
Language : 

SH7032 Datasheet, PDF (442/687 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer
Section 14 A/D Converter
Bit 7—A/D End Flag (ADF): ADF indicates that A/D conversion is completed.
Bit 7 (ADF)
0
1
Description
Cleared to 0 under the following conditions:
(Initial value)
• The CPU reads the ADF bit while the bit is set to 1, then writes 0 in the bit
• The ADI starts the DMAC and the A/D conversion register is accessed
Set to 1 at the following times:
• Single mode: When A/D conversion is complete
• Scan mode: When A/D conversion of all selected channels is complete
Bit 6—A/D Interrupt Enable (ADIE): ADIE selects whether or not an A/D interrupt (ADI) is
requested when A/D conversion is completed.
Bit 6 (ADIE)
0
1
Description
The A/D interrupt (ADI) request is disabled
The A/D interrupt (ADI) request is enabled
(Initial value)
Bit 5—A/D Start (ADST): ADST selects the start or halting of A/D conversion. Whenever the
A/D converter is operating, this bit is set to 1. It can also be set to 1 by the A/D conversion trigger
input pin (ADTRG).
Bit 5 (ADST)
0
1
Description
A/D conversion is halted
(Initial value)
• Single mode: A/D conversion is performed. This bit is automatically cleared
to 0 at the end of the conversion.
• Scan mode: A/D conversion starts and continues cyclically on the selected
channels until this bit is cleared to 0 by software, a reset, or standby mode.
Bit 4—Scan Mode (SCAN): SCAN selects either scan mode or single mode for operation. See
section 14.4, Operation, for descriptions of these modes. The mode should be changed only when
the ADST bit is cleared to 0.
Bit 4 (SCAN)
0
1
Description
Single mode
Scan mode
(Initial value)
Rev. 7.00 Jan 31, 2006 page 416 of 658
REJ09B0272-0700