SH7032 Datasheet, PDF (153/687 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

8.3 Address Space Subdivision
8.3.1 Address Spaces and Areas
Figure 8.3 shows the address format used in this chip.
Section 8 Bus State Controller (BSC)
4-Gbyte space
128-Mbyte space
16-Mbyte space
4-Mbyte space
A31–A28 A27 A26–A24 A23,A22 A21
A0
Output address:
Output from address pins
A21–A0
Ignored: Only valid when the address multiplex
function is being used in the DRAM space (area 1);
not output in other cases. When not output,
becomes shadow.
Area selection:
Decoded to become chip select signals CS0–CS7 for areas 0–7
Basic bus width selection:
Not output externally, but used for basic bus width selection
When 0, (H'0000000–H'7FFFFFF), the basic bus width is 8 bits.
When 1, (H'8000000–H'FFFFFFF), the basic bus width is 16 bits.
Ignored: Always ignored, not output externally
Figure 8.3 Address Format
Since this chip uses a 32-bit address, 4 Gbytes of space can be accessed in the architecture;
however, the upper 4 bits (A31–A28) are always ignored and not output. Bit A27 is basically only
used for switching the bus width. When the A27 bit is 0 (H'0000000–H'7FFFFFF), the bus width
is 8 bits; when the A27 bit is 1 (H'8000000–H'FFFFFFF), the bus width is 16 bits. With the
remaining 27 bits (A26–A0), a total of 128 Mbytes can thus be accessed.
The 128-Mbyte space is subdivided into 8 areas (areas 0–7) of 16 Mbytes each according to the
values of bits A26–A24. The space with bits A26–A24 as 000 is area 0 and the space with bits
A26–A24 as 111 is area 7. The A26–A24 bits are decoded and are output as the chip select signals
(CS0–CS7) of the corresponding areas 0–7. Table 8.7 shows how the space is divided.
Rev. 7.00 Jan 31, 2006 page 127 of 658
REJ09B0272-0700