SH7047 Datasheet, PDF (586/764 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTMRISC engine Family/SH7000 Series

18.5 Port F
Port F is an input-only port with the 16 pins shown in figure 18.5.
Port F
PF15 (input) / AN15 (input)
PF14 (input) / AN14 (input)
PF13 (input) / AN13 (input)
PF12 (input) / AN12 (input)
PF11 (input) / AN11 (input)
PF10 (input) / AN10 (input)
PF9 (input) / AN9 (input)
PF8 (input) / AN8 (input)
PF7 (input) / AN7 (input)
PF6 (input) / AN6 (input)
PF5 (input) / AN5 (input)
PF4 (input) / AN4 (input)
PF3 (input) / AN3 (input)
PF2 (input) / AN2 (input)
PF1 (input) / AN1 (input)
PF0 (input) / AN0 (input)
Figure 18.5 Port F
18.5.1 Register Descriptions
Port F is a 16-bit input-only port. Port F has the following register. For details on register
addresses and register states during each processing, refer to appendix A, Internal I/O Register.
• Port F data register (PFDR)
18.5.2 Port F Data Register (PFDR)
The port F data register (PFDR) is a 16-bit read-only register that stores port F data.
Bits PF15DR to PF0DR correspond to pins PF15 to PF0 (multiplexed functions omitted here).
Any value written into these bits is ignored, and there is no effect on the state of the pins. When
any of the bits are read, the pin state rather than the bit value is read directly. However, when an
Rev. 2.00, 09/04, page 546 of 720