SH7047 Datasheet, PDF (394/764 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTMRISC engine Family/SH7000 Series

12.4.3 Clock
Either an internal clock generated by the on-chip baud rate generator or an external clock input at
the SCK pin can be selected as the SCI’s serial clock, according to the setting of the C/A bit in
SMR and the CKE1 and CKE0 bits in SCR. When an external clock is input at the SCK pin, the
clock frequency should be 16 times the bit rate used.
When the SCI is operated on an internal clock, the clock can be output from the SCK pin. The
frequency of the clock output in this case is equal to the bit rate, and the phase is such that the
rising edge of the clock is in the middle of the transmit data, as shown in figure 12.4.
The clock must not be stopped during operation.
SCK
TxD
0 D0 D1 D2 D3 D4 D5 D6 D7 0/1 1 1
1 frame
Figure 12.4 Relation between Output Clock and Transmit Data Phase
(Asynchronous Mode)
Rev. 2.00, 09/04, page 354 of 720