HD6432345 Datasheet, PDF (95/907 Pages) Hitachi Semiconductor – H8S/2345 F-ZTAT Hardware Manual

3.3 Operating Mode Descriptions
3.3.1 Mode 1 (ZTAT, Mask ROM, and ROMless Versions Only)
The CPU can access a 64-kbyte address space in normal mode. The on-chip ROM is disabled, and
8-bit bus mode is set, immediately after a reset.
Ports B and C function as an address bus, port D functions as a data bus, and part of port F carries
bus control signals. However, note that if 16-bit access is designated by the bus controller, the bus
mode switches to 16 bits and port E becomes a data bus.
3.3.2 Mode 2*¹ (ZTAT and Mask ROM Versions Only)
The CPU can access a 64-kbyte address space in normal mode. The on-chip ROM is enabled, and
8-bit bus mode is set. immediately after a reset.
Ports B and C function as input ports immediately after a reset. They can each be set to output
addresses by setting the corresponding bits in the data direction register (DDR) to 1. Port D
functions as a data bus, and part of port F carries bus control signals. However, note that if 16-bit
access is designated by the bus controller, the bus mode switches to 16 bits and port E becomes a
data bus.
The amount of on-chip ROM that can be used is limited to 56 kbytes.
3.3.3 Mode 3*¹ (ZTAT and Mask ROM Versions Only)
The CPU can access a 64-kbyte address space in normal mode. The on-chip ROM is enabled, but
external addresses cannot be accessed.
All I/O ports are available for use as input-output ports.
The amount of on-chip ROM that can be used is limited to 56 kbytes.
3.3.4 Mode 4*²
The CPU can access a 16-Mbyte address space in advanced mode. The on-chip ROM is disabled.
Pins P1₃ to P1₀, ports A, B and C function as an address bus, ports D and E function as a data bus,
and part of port F carries bus control signals. Pins P1₃ to P1₀ function as inputs immediately after a
reset. Each of these pins can be set to output addresses by setting the corresponding bit in the data
direction register (DDR) to 1.
The initial bus mode after a reset is 16 bits, with 16-bit access to all areas. However, note that if
8-bit access is designated by the bus controller for all areas, the bus mode switches to 8 bits.
75