HD6432345 Datasheet, PDF (283/907 Pages) Hitachi Semiconductor – H8S/2345 F-ZTAT Hardware Manual

8.11.2 Register Configuration
Table 8.19 shows the port F register configuration.
Table 8.19 Port F Registers
Name
Abbreviation
R/W
Port F data direction register
PFDDR
W
Port F data register
PFDR
R/W
Port F register
PORTF
R
Notes: 1. Lower 16 bits of the address.
2. Initial value depends on the mode.
Initial Value
H'80/H'00*²
H'00
Undefined
Address *¹
H'FEBE
H'FF6E
H'FF5E
Port F Data Direction Register (PFDDR)
Bit
:
7
6
5
4
3
2
1
0
PF7DDR PF6DDR PF5DDR PF4DDR PF3DDR PF2DDR PF1DDR PF0DDR
Modes 1, 2, 4, 5, 6*
Initial value :
1
0
0
0
0
0
0
0
R/W
:
W
W
W
W
W
W
W
W
Modes 3 and 7*
Initial value :
0
0
0
0
0
0
0
0
R/W
:
W
W
W
W
W
W
W
W
PFDDR is an 8-bit write-only register, the individual bits of which specify input or output for the
pins of port F. PFDDR cannot be read; if it is, an undefined value will be read.
PFDDR is initialized by a power-on reset, and in hardware standby mode, to H'80 in modes 1, 2,
4, 5, and 6*, and to H'00 in modes 3 and 7*. It retains its prior state after a manual reset, and in
software standby mode. The OPE bit in SBYCR is used to select whether the bus control output
pins retain their output state or become high-impedance when a transition is made to software
standby mode.
Note: * Modes 1 to 3 are not available on the F-ZTAT version.
Modes 2, 3, 6, and 7 are not available on the ROMless version.
266