HD6432345 Datasheet, PDF (265/907 Pages) Hitachi Semiconductor – H8S/2345 F-ZTAT Hardware Manual

8.7.4 MOS Input Pull-Up Function
Port B has a built-in MOS input pull-up function that can be controlled by software. This MOS
input pull-up function can be used in modes 2, 3, 6, and 7, and can be specified as on or off on an
individual bit basis.
When a PBDDR bit is cleared to 0 in mode 2, 3, 6, or 7, setting the corresponding PBPCR bit to 1
turns on the MOS input pull-up for that pin.
The MOS input pull-up function is in the off state after a power-on reset, and in hardware standby
mode. The prior state is retained after a manual reset, and in software standby mode.
Table 8.12 summarizes the MOS input pull-up states.
Table 8.12 MOS Input Pull-Up States (Port B)
Modes
Power-On Hardware
Manual Software
Reset
Standby Mode Reset Standby Mode
1, 4, 5*
OFF
OFF
2, 3, 6, 7*
ON/OFF
Legend:
OFF : MOS input pull-up is always off.
ON/OFF : On when PBDDR = 0 and PBPCR = 1; otherwise off.
In Other
Operations
Note: * Modes 1 to 3 are not available on the F-ZTAT version.
Modes 2, 3, 6, and 7 are not available on the ROMless version.
248