HD6432345 Datasheet, PDF (116/907 Pages) Hitachi Semiconductor – H8S/2345 F-ZTAT Hardware Manual

Internal Prefetch of first
Vector fetch _{processing program instruction}
ø
RES
*
*
*
Address bus
RD
HWR, LWR
D₁₅ to D₀
(1)
(3)
High
(2)
(4)
(5)
(6)
(1) (3) Reset exception handling vector address ((1) = H'000000, (3) = H'000002)
(2) (4) Start address (contents of reset exception handling vector address)
(5) Start address ((5) = (2) (4))
(6) First program instruction
Note: * 3 program wait states are inserted.
Figure 4.3 Reset Sequence (Mode 4)
4.2.4 Interrupts after Reset
If an interrupt is accepted after a reset but before the stack pointer (SP) is initialized, the PC and
CCR will not be saved correctly, leading to a program crash. To prevent this, all interrupt requests,
including NMI, are disabled immediately after a reset. Since the first instruction of a program is
always executed immediately after the reset state ends, make sure that this instruction initializes
the stack pointer (example: MOV.L #xx:32, SP).
4.2.5 State of On-Chip Supporting Modules after Reset Release
After reset release, MSTPCR is initialized to H'3FFF and all modules except the DTC enter
module stop mode. Consequently, on-chip supporting module registers cannot be read or written
to. Register reading and writing is enabled when module stop mode is exited.
96