HD6432345 Datasheet, PDF (276/907 Pages) Hitachi Semiconductor – H8S/2345 F-ZTAT Hardware Manual

Port D pin functions in modes 3 and 7 are shown in figure 8.19.
Port D
PD₇ (I/O)
PD₆ (I/O)
PD₅ (I/O)
PD₄ (I/O)
PD₃ (I/O)
PD₂ (I/O)
PD₁ (I/O)
PD₀ (I/O)
Figure 8.19 Port D Pin Functions (Modes 3 and 7)*
8.9.4 MOS Input Pull-Up Function
Port D has a built-in MOS input pull-up function that can be controlled by software. This MOS
input pull-up function can be used in modes 3 and 7*, and can be specified as on or off on an
individual bit basis.
When a PDDDR bit is cleared to 0 in mode 3 or 7*, setting the corresponding PDPCR bit to 1
turns on the MOS input pull-up for that pin.
The MOS input pull-up function is in the off state after a power-on reset, and in hardware standby
mode. The prior state is retained after a manual reset, and in software standby mode.
Table 8.16 summarizes the MOS input pull-up states.
Table 8.16 MOS Input Pull-Up States (Port D)
Modes
Power-On Hardware
Manual Software
Reset
Standby Mode Reset Standby Mode
1, 2, 4 to 6*
OFF
OFF
3, 7*
ON/OFF
Legend:
OFF : MOS input pull-up is always off.
ON/OFF : On when PDDDR = 0 and PDPCR = 1; otherwise off.
In Other
Operations
Note: * Modes 1 to 3 are not available on the F-ZTAT version.
Modes 2, 3, 6, and 7 are not available on the ROMless version.
259