SH7203 Datasheet, PDF (1280/1686 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series

Section 24 LCD Controller (LCDC)
Initial
Bit
Bit Name Value R/W Description
12
VEINTEN 0
R/W Vsync Ending Point Interrupt Enable
Enables or disables the generation of an interrupt at the
end point of LCDC's Vsync.
0: Interrupt at the end point of the Vsync signal is
disabled
1: Interrupt at the end point of the Vsync signal is
enabled
11
MINTS
0
R/W Memory Access Interrupt State
Indicates the memory access interrupt handling state.
This bit indicates 1 when the LCDC memory access
interrupt is generated (set state). During the memory
access interrupt handling routine, this bit should be
cleared by writing 0.
0: LCDC did not generate a memory access interrupt or
has been informed that the generated memory
access interrupt has completed
1: LCDC has generated a memory access end interrupt
and not yet been informed that the generated
memory access interrupt has completed
10
FINTS
0
R/W Flame End Interrupt State
Indicates the flame end interrupt handling state.
This bit indicates 1 at the time when the LCDC flame
end interrupt is generated (set state). During the flame
end interrupt handling routine, this bit should be cleared
by writing 0.
0: LCDC did not generate a flame end interrupt or has
been informed that the generated flame end interrupt
has completed
1: LCDC has generated a flame end interrupt and not
yet been informed that the generated flame end
interrupt has completed
Rev. 2.00 Apr. 16, 2008 Page 1250 of 1652
REJ09B0313-0200