English
Language : 

D12320VF25V Datasheet, PDF (839/1146 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents
19.2.2 System Clock Control Register (SCKCR)
Bit
:
7
6
5
4
PSTOP —
DIV
—
Initial value :
0
0
0
0
R/W
: R/W
R/W
R/W
—
Section 19 Power-Down Modes
3
2
1
0
—
SCK2 SCK1 SCK0
0
0
0
0
—
R/W
R/W
R/W
SCKCR is an 8-bit readable/writable register that controls φ clock output, the medium-speed mode
in which the bus master runs on a medium-speed clock and the other supporting modules run on
the high-speed clock, and a function that allows the medium-speed mode to be disabled and the
clock division ratio to be changed for the entire chip.
SCKCR is initialized to H'00 by a reset and in hardware standby mode. It is not initialized in
software standby mode.
Bit 7—φ Clock Output Disable (PSTOP): Controls φ output.
Bit 7
PSTOP
0
1
Normal
Operating Mode
φ output (Initial value)
Fixed high
Description
Software
Sleep Mode Standby Mode
φ output
Fixed high
Fixed high
Fixed high
Hardware
Standby Mode
High impedance
High impedance
Bit 6—Reserved: This bit can be read or written to, but only 0 should be written.
Bit 5—Division Ratio Select (DIV): When the DIV bit is set to 1, the medium-speed mode is
disabled and a clock obtained using the division ratio set with bits SCK2 to SCK0 is supplied to
the entire chip. In this way, the current dissipation within the chip is reduced in proportion to the
division ratio. As the frequency of φ changes, the following points must be noted.
• The division ratio set with bits SCK2 to SCK0 should be selected so as to fall within the
guaranteed operation range of clock cycle time tcyc given in the AC timing table in the
Electrical Characteristics section. Ensure that φ min = 2 MHz, and the condition φ < 2 MHz
does not arise.
• All internal modules basically operate on φ. Note, therefore, that time processing involving the
timers, the SCI, etc., will change when the division ratio changes. The wait time when software
standby is cleared will also change in line with a change in the division ratio.
Rev.7.00 Feb. 14, 2007 page 805 of 1108
REJ09B0089-0700