D12320VF25V Datasheet, PDF (240/1146 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 7 Data Transfer Controller
7.3.8 Chain Transfer
Setting the CHNE bit to 1 enables a number of data transfers to be performed consecutively in
response to a single transfer request. It is also possible, by setting both the CHNE bit and CHNS
bit to 1, to specify execution of chain transfer only when the transfer counter value is 0. SAR,
DAR, CRA, CRB, MRA, and MRB, which define data transfers, can be set independently.
Figure 7.9 shows the memory map for chain transfer.
Source
DTC vector
address
Register information
start address
Register information
CHNE = 1
Register information
CHNE = 0
Destination
Source
Destination
Figure 7.9 Chain Transfer Memory Map
In the case of transfer with CHNE set to 1, an interrupt request to the CPU is not generated at the
end of the specified number of transfers or by setting of the DISEL bit to 1, and the interrupt
source flag for the activation source is not affected.
Rev.7.00 Feb. 14, 2007 page 206 of 1108
REJ09B0089-0700