D12320VF25V Datasheet, PDF (625/1146 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 17 ROM
Start
Set pins to boot mode
and execute reset-start
Host transfers data (H'00)
continuously at prescribed bit rate
Chip measures low period
of H'00 data transmitted by host
Chip calculates bit rate and
sets value in bit rate register
After bit rate adjustment, chip
transmits one H'00 data byte to
host to indicate end of adjustment
Host confirms normal reception
of bit rate adjustment end
indication (H'00), and transmits
one H'55 data byte
After receiving H'55,
chip transmits one H'AA
data byte to host
Host transmits number
of programming control program
bytes (N), upper byte followed
by lower byte
Chip transmits received
number of bytes to host as verify
data (echo-back)
n=1
Host transmits programming control
program sequentially in byte units
Chip transmits received
programming control program to
host as verify data (echo-back)
Transfer received programming
control program to on-chip RAM
n = N?
No
Yes
End of transmission
Check flash memory data, and
if data has already been written,
erase all blocks
After confirming that all flash
memory data has been erased,
chip transmits one H'AA data
byte to host
Execute programming control
program transferred to on-chip RAM
n+1→n
Note: If a memory cell does not operate normally and cannot be erased, one H'FF byte is
transmitted as an erase error, and the erase operation and subsequent operations
are halted.
Figure 17.10 Boot Mode Execution Procedure
Rev.7.00 Feb. 14, 2007 page 591 of 1108
REJ09B0089-0700