D12320VF25V Datasheet, PDF (500/1146 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 12 Serial Communication Interface (SCI)
Serial data transmission (asynchronous mode): Figure 12.5 shows a sample flowchart for serial
transmission.
The following procedure should be used for serial data transmission.
Initialization
Start of transmission
Read TDRE flag in SSR
TDRE = 1?
Yes
Write transmit data to TDR
and clear TDRE flag in SSR to 0
All data transmitted?
Yes
Read TEND flag in SSR
TEND = 1?
Yes
Break output?
Yes
Clear DR to 0 and
set DDR to 1
[1] ^{[1] SCI initialization:}
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1, a frame
[2]
of 1s is output, and transmission is
enabled.
No
[2] SCI status check and transmit data
write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR and clear the
TDRE flag to 0.
[3] Serial transmission continuation
procedure:
No
To continue serial transmission,
read 1 from the TDRE flag to
confirm that writing is possible,
then write data to TDR, and then
[3]
clear the TDRE flag to 0. Checking
and clearing of the TDRE flag is
automatic when the DTC is
activated by a transmit-data-empty
No
interrupt (TXI) request, and data is
written to TDR.
[4] Break output at the end of serial
transmission:
No
[4]
To output a break in serial
transmission, set DDR for the port
corresponding to the TxD pin to 1,
clear DR to 0, then clear the TE bit
in SCR to 0.
Clear TE bit in SCR to 0
<End>
Figure 12.5 Sample Serial Transmission Flowchart
Rev.7.00 Feb. 14, 2007 page 466 of 1108
REJ09B0089-0700