D12320VF25V Datasheet, PDF (837/1146 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 19 Power-Down Modes
19.2 Register Descriptions
19.2.1 Standby Control Register (SBYCR)
Bit
:
7
6
5
4
3
2
SSBY STS2 STS1 STS0 OPE
—
Initial value :
0
0
0
0
1
0
R/W
: R/W
R/W
R/W
R/W
R/W
—
1
0
— IRQ37S
0
0
—
R/W
SBYCR is an 8-bit readable/writable register that performs software standby mode control.
SBYCR is initialized to H'08 by a reset and in hardware standby mode. It is not initialized in
software standby mode.
Bit 7—Software Standby (SSBY): Specifies a transition to software standby mode. Remains set
to 1 when software standby mode is released by an external interrupt, and a transition is made to
normal operation. The SSBY bit should be cleared by writing 0 to it.
Bit 7
SSBY
0
1
Description
Transition to sleep mode after execution of SLEEP instruction
(Initial value)
Transition to software standby mode after execution of SLEEP instruction
Bits 6 to 4—Standby Timer Select 2 to 0 (STS2 to STS0): These bits select the time the MCU
waits for the clock to stabilize when software standby mode is cleared by an external interrupt.
With crystal oscillation, refer to table 19.4 and make a selection according to the operating
frequency so that the standby time is at least 8 ms (the oscillation stabilization time). With an
external clock, any selection can be made*.
Note: * Except in the F-ZTAT versions.
Rev.7.00 Feb. 14, 2007 page 803 of 1108
REJ09B0089-0700