D12320VF25V Datasheet, PDF (440/1146 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 10 8-Bit Timers
10.4 Interrupts
10.4.1 Interrupt Sources and DTC Activation
There are three 8-bit timer interrupt sources: CMIA, CMIB, and OVI. Their relative priorities are
shown in table 10.3. Each interrupt source is set as enabled or disabled by the corresponding
interrupt enable bit in TCR, and independent interrupt requests are sent for each to the interrupt
controller. It is also possible to activate the DTC by means of CMIA and CMIB interrupts.
Table 10.3 8-Bit Timer Interrupt Sources
Channel Interrupt Source Description
DTC Activation
Priority
0
CMIA0
Interrupt by CMFA
Possible
High
CMIB0
Interrupt by CMFB
Possible
OVI0
Interrupt by OVF
Not possible
1
CMIA1
Interrupt by CMFA
Possible
CMIB1
Interrupt by CMFB
Possible
OVI1
Interrupt by OVF
Not possible
Low
Note: This table shows the initial state immediately after a reset. The relative channel priorities
can be changed by the interrupt controller.
10.4.2 A/D Converter Activation
The A/D converter can be activated only by channel 0 compare match A.
If the ADTE bit in TCSR0 is set to 1 when the CMFA flag is set to 1 by the occurrence of channel
0 compare match A, a request to start A/D conversion is sent to the A/D converter. If the 8-bit
timer conversion start trigger has been selected on the A/D converter side at this time, A/D
conversion is started.
Rev.7.00 Feb. 14, 2007 page 406 of 1108
REJ09B0089-0700