HD64F3048VTF8 Datasheet, PDF (491/903 Pages) Renesas Technology Corp – Hardware Manual Renesas 8-Bit Single-Chip

Section 13 Serial Communication Interface
Bit 3—Stop Bit Length (STOP): Selects one or two stop bits in asynchronous mode. This setting
is used only in asynchronous mode. In synchronous mode no stop bit is added, so the STOP bit
setting is ignored.
Bit 3: STOP
Description
0
One stop bit^*1
(Initial value)
1
Two stop bits^*2
Notes: 1. One stop bit (with value 1) is added at the end of each transmitted character.
2. Two stop bits (with value 1) are added at the end of each transmitted character.
In receiving, only the first stop bit is checked, regardless of the STOP bit setting. If the second
stop bit is 1 it is treated as a stop bit. If the second stop bit is 0 it is treated as the start bit of the
next incoming character.
Bit 2—Multiprocessor Mode (MP): Selects a multiprocessor format. When a multiprocessor
format is selected, parity settings made by the PE and O/E bits are ignored. The MP bit setting is
valid only in asynchronous mode. It is ignored in synchronous mode.
For further information on the multiprocessor communication function, see section 13.3.3,
Multiprocessor Communication.
Bit 2: MP
0
1
Description
Multiprocessor function disabled
Multiprocessor format selected
(Initial value)
Bits 1 and 0—Clock Select 1 and 0 (CKS1, CKS0): These bits select the clock source of the on-
chip baud rate generator. Four clock sources are available: φ, φ/4, φ/16, and φ/64.
For the relationship between the clock source, bit rate register setting, and baud rate, see section
13.2.8, Bit Rate Register (BRR).
Bit 1: CKS1
0
1
Bit 0: CKS0
0
1
0
1
Description
φ
φ/4
φ/16
φ/64
(Initial value)
Rev. 3.00 Sep 27, 2006 page 463 of 872
REJ09B0325-0300